This topic contains 1 reply, has 2 voices, and was last updated by Novaline – Mystery Islands Music Support 2 months, 2 weeks ago.
- 04/12/2018 at 02:10 #46024
With the proper MIDI interface (a MOTU MicroLite for example) will I be able to use both SN2X and MicroQxR at the same time on Windows in Ableton Live?
Does LoopBe/MidiOX allow for this?
- 06/01/2019 at 15:28 #47258
Novaline – Mystery Islands Music SupportModerator@novaline
Yes, as long as you have enough midi ports for your synthesizers you will be. Doesnt matter what OS you use.
As long your midi device has drivers that supports your OS and have enough ports for your gear, you´ll be just fine!
it would be a different story if you had a 1 port midi in and 1 midi out and have 2 synthesizers.
And LOOPbe is not necessary in this case. you need only LOOPmidi and MIDI-OX.
please following instructions:
-create virtual channels for your synths
(exampe: SUPERNOVA 2 IN & SUPERNOVA 2 OUT)
-follow the photo as shown that i provide
-when all that is done. Go to your DAW and midi settings and activate the you SUPERNOVA 2 OUT on the OUTPUT section on the port number it is connected.
-follow the photos ive sent and once its done. open the editor and choose your ports and sync data to hardware. All done!
hope this helps!
STUDIO GEAR: RME FIREFACE 802, ALESIS AI3, EVE AUDIO SC 207, ROLAND JP8000, ROLAND JP8080, NOVATION SUPERNOVA, ACCESS VIRUS A, WALDORF PULSE, ROLAND SH201
You must be logged in to access attached files.
You must be logged in to reply to this topic.